Two arcs error

Jun 21 at 11:48 PM
Edited Jun 22 at 9:49 PM
I have small problem with two arcs one next to the other. It looks like the other software packages are reading this correctly, but when I use NetDXF I have 'Parameter is too big or too small for Int32' error message.

After some further tests I found that the two arcs are not touching each other ( very close) and this is what crashed the dll.

If I insert a small line between the end point of the first arc and the beginning of the second I can read the file with no problem.
Can someone help?
Jun 22 at 10:30 PM
Please, open an Issue and upload your dxf, so I can take a look at it.